WIND TURBINE CHARGE CONTROLLER 1500W 24V48V 2000W WATERPROOF GENERATOR REGULATOR. This controller can control wind turbines to charge the battery automatically. When the battery is fully charged, brake can be controlled automatically by the interior circuit.When the battery voltage drops to restore voltage level, wind turbine can automatically recover to the battery charging, so as to protect the wind turbine and the battery. Voltage and current limiting are be enabled during recharging to ensure the best charging effect.
Meanwhile, it provides the maximum protection to the wind turbine and battery. Unique reverse connect protection circuit. For improper operation the positive and negative of battery, don't need to replace the fuse, only to reset the positive and negative in correct point. So the whole system will be more reliable. LED indicate circuit working condition, concise, intuitive, and clear.With the independent intellectual property rights of modular design, which makes the performance of the whole system to get the biggest safeguard. Rectification of this controller and braking circuit part, have adopted the company design integration module, no matter from heat, or reliability, further than the traditional design. If the controller without waterproof but used in easy ooze water environment or the humidity is heavy, then the controller is easy to be corroded and damaged. Our product adopts full seal completely waterproof design which adapt to the heavy humidity, salinity, such as ground water operational environment.
The protection grade reaches the IP67 above, even in water can steadily work normally for a long time. Approved ISO9001 quality management system, our factory strictly controls the production and testing quality which guarantees the high quality in maximum.
Workable temperature is from - 35 75degree. Battery over discharge recover voltage. Wind charge cruuent detection, wind generator and battery transposition protection, battery, overcharge.
Protection, short circuit protection, autobrake function. First: connect the red and black lines with the "+" &"-" of the battery bank. When the green "Battery Light" lights on, which means that the battery is connected correctly, then can continue the second step. Next: connect the three green wires with the output wires of the wind turbine generator.
The green "Charge Light" flashes, which means that the wind generator works and is charging the battery. Flashing speed shows the rotate speed of wind turbine generator. When the wind turbine generator is braking, the another red "Brake Light" will be on, which usually happen when the battery full charged or the wind speed too high. Please be sure to notice. 1 the rated output voltage of wind turbine generator needs to be same with the rated voltage of battery bank.
2 the controller must firstly be connected with the battery, then can connect wind turbine generator. There may be some delays due to flight, holiday, weather, local post, local natural disaster impact. It must also be in the original packaging. This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits".
The seller is "ginmega" and is located in this country: CN. This item can be shipped worldwide.